Remote-processing RPC-210 Uživatelský manuál stáhnout pdf (Strana 9)

SETUP AND OPERATION SECTION 2

Page 2-3

Figure 2-1 Power and Serial Progr amming

Figure 2-2 Power input locations

FIRST TIME OPERATION

Become familiar with the locations of connectors before

getting started. See Figure 2-1. RPC-210 jumpers have

been set at the factory to operate the system immediately

using a 6 - 16 V supply. If you have a 5V supply, then

remove jumper W8 and connect the + 5V to P1 terminal

marked ‘5' . For first time operation, do not install any

connectors or parts unless specified below. Jumpers

should be kept in default positions.

1. Connect power.

A development system includes a power supply and

cable assembly. Refer to the next two paragraphs

for connection instructions then move on to

paragraph 2.

Development system power supply

Refer to Figure 2-1 on the next page. Connect the

red wire on the power cable assem bly (P/ N 1725) to

the terminal marked “E” on P1. Black goes to P1

terminal marked "G".

You may plug the power supply into a 120 VAC

wall outlet or power strip. Power may be applied or

removed from the RPC-210 board by plugging the

3.5mm connector from the power supply to the

power cable assembly.

Your ow n power supply

The RPC-210 needs + 5 volts or 6 to 16 volts at 300

ma. The RPC-210 has its own regulator which

supplies 5V to the rest of the card when power is

applied to the ' E' termin al.

Be careful when using "switching" power supplies.

Some supplies do not regulate properly unless they

are adequately loaded.

Make sure pow er is off. Conne ct the powe r supply

to one of the appropriately marked terminals on the

RPC-210 as shown below.

Power connector P1 is designated as ' 5' for 5 volts,

' E' for the external 6-16 volt input, and ' G' for

ground. Other terminals marked ‘B’ and ‘P’ are

discussed in Section 7, REAL TIM E CLOCK.

Connect power to P1 as appropriate from your

supply as shown below.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Remote-processing RPC-210 Uživatelský manuál Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Počítače Remote-processing RPC-210